How Do You Reset The Anti Theft System On A Dodge Ram
How do you reset the anti theft system on a dodge ram. Insert the ignition key and turn it to the on position and then attempt to start the engine crank over the engine wont start. The most typical communication error is with the ignition key itself. 2007 Dodge Caliber 120000 mi I had this problem and can easily be fixed by locating the ingnition fuse pulling it out and putting it right back in.
This method uses the door lock of your Ford to reset the system. Check the anti-theft light again. It also acts as the keyless entry receiver.
Disconnect the positive terminal of the battery for a minute or two. Open the fuse box under the hood and find the IOD fuse. The cars engine should start as you have successfully reset the anti-theft system of your Ford.
Dodge Chrysler Jeep Alarm Reset. The security system on a Dodge Caravan acts as an anti-theft deterrent. Once I unlocked the.
Then put the key back in and try to start the car. It is another way to solve the problem of anti theft system car wont start. It will reset the computer system and your car is likely to kick off.
Then lock and unlock the doors with the keyless entry fob or the actual key. This is why they did not take the car your anti theft system did exactly what it was designed to do. This is the module in the steering column that communicates with a transponder chip in the key to allow the engine to start and run.
Asked by C_Killa Mar 29 2019 at 0920 AM about the 2000 Dodge RAM 1500 SLT Quad Cab 4WD. Repeat the process at least a couple of times if it does not work the first time.
To reset the anti theft system in a dodge ram 1500 series put the key in the ignition in the on position with the engine off for 60 seconds.
1If you have other security keys on the same key ring or any other electronic fob on your key ring it may cause a communication error with the reciever in the stering column at any time. Do not buy a new control module. Dodge Chrysler Jeep Alarm Reset. To reset the anti theft system in a dodge ram 1500 series put the key in the ignition in the on position with the engine off for 60 seconds. Hi ok this is likely nothing to do with the anti-theft but do this to reset the security system. This allows the alarm enough time to reset its timer. Its the 14 digit number under the top barcode usually starts with T00. Asked by C_Killa Mar 29 2019 at 0920 AM about the 2000 Dodge RAM 1500 SLT Quad Cab 4WD. With the key still in the run position wait 10 minutes and the security light should blink and then go out.
However you can also hold the terminal away from the battery for approximately five minutes. The last step is to locate the relay box which is located beneath the Dodge Ram hood. Then lock and unlock the doors with the keyless entry fob or the actual key. Fuse 51 is the IOD ignition off draw fuse. Your dodge has an antitheft system that shuts down the ignition and fuel system when the lock was tampered with. Once ten minutes has passed come back and check the anti-theft light. It will reset the computer system and your car is likely to kick off.
Post a Comment for "How Do You Reset The Anti Theft System On A Dodge Ram"